Tweco ArcMaster 401MST Manual do Utilizador descarregar pdf (Página 75)

ARCMASTER 401MST POWER SOURCE

Manual 0-5287 5-3 POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS

Code Error Cause Possible Remedy

E08-11 V/I Acquisition Voltage/current measuring

systems faulty

Take to an accredited Tweco Service

Center for repair.

E08-13 CAN Identiﬁcation Unknown device connected Check connected devices and CAN

connections

E09 Output Voltage Voltage measuring system

faulty.

Torch is touching work piece

Take to an accredited Tweco Service

Center for repair.

Raise Torch from contact with work

piece.

E12 Power Section Power section start-up faulty.

Torch is touching work piece

Take to an accredited Tweco Service

Center for repair.

Raise Torch from contact with work

piece.

E13 Temperature Sensor Temperature sensor not ready

for operation

Take to an accredited Tweco Service

Center for repair.

E14 Supply Voltage Internal supply voltage too low Check mains voltages

E15 Current Detection Error during current measure-

ment

Take to an accredited Tweco Service

Center for repair.

E18 Overload Protection Safety switch device to protect

elec trical components

Take to an accredited Tweco Service

Center for repair.

E22 Mains Undervoltage Mains voltage on power unit is

too low

Check mains voltages

E25 Idle Generator Idle generator faulty Take to an accredited Tweco Service

Center for repair.

E30 Error Conﬁguration Faulty or wrong pc-board,

wrong software system

installed

Take to an accredited Tweco Service

Center for repair.

E31 Communications Fault CAN bus communication

faulty

Switch the equipment off and on

again

E32 FPGA FPGA faulty Take to an accredited Tweco Service

Center for repair.

E33 Power Section Power module not symmetri-

cal

Take to an accredited Tweco Service

Center for repair.

E34 Fans Fan current faulty Take to an accredited Tweco Service

Center for repair.

E39 Protective Earth Conductor

Monitoring

Fault current to protective

earth con ductor

Connect the welding earth lead

E40 Voltage detection Voltage measurement faulty at

the socket

Take to an accredited Tweco Service

Center for repair.

E47 Undeﬁned Mains Mains voltage between per-

mitted ranges

Check mains

Table 5-2 Power Source Error Messages

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 83 84

Comentários a estes Manuais

Sem comentários

Tweco ArcMaster 401MST Manual do Utilizador Página 75

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Tweco ArcMaster 401MST